[. . . ] RPM4TM Rack Mount Kit P/N 401929 Installation Instructions RACK MOUNT KIT, P/N 401929, INCLUDES QTY 1 2 4 4 4 4 1 1 4 PART NO 123699 124155 100972-Z 102668-Z 101016-Z 100918-Z 123703 123764 103448-Z FIGURE CALLOUT 1 2 3 4 5 6 7 8 N/A DESCRIPTION Front panel Side bracket M4 hex nut M4 split lock washer M4 x 12 SHC screw M4 flat washer Rear support bracket Foam gasket M3 x 12 self-tapping screw INSTALLATION INSTRUCTIONS Remove the four feet from the bottom of the RPM4TM by removing the screw and then removing the foot. [. . . ] Attach the front panel (1) to the side brackets (2) using four M4 split lock washers (4) and four M4 hex nuts (3). Adhere the foam strip to the rear support bracket (7), centering the foam as shown in figure 2. Attach the rear support bracket (7) to the side brackets (2) using four M4 flat washers (6) and four M4 X 12 SHC screws (5). For adequate support of the RPM4, the rear support bracket (7) shall be supported on the side rails of the rack system or by other means. Figure 1. [. . . ] Document 560061b 041124 DH Instruments, Inc. 4765 East Beautiful Lane Phoenix AZ 85044-5318 USA Tel 602. 431. 9100 Fax 602. 431. 9559 dhi@dhinstruments. com www. dhinstruments. com [. . . ]